Copy of PC0110 Installation Tutorial
1. Please refer to the official information given by ROG for changes in the repair policy of the whole machine caused by disassembling the machine.
2. To minimize the risk of damage, power on the device and discharge the battery to less than 25%, turn the ROG Ally off and unplug all cables, and if you have a microSD card installed, make sure to remove it before disassembling.
3. When servicing your device, please follow the general anti-static safety procedures, keep the removed original parts in a safe place, manage your screws and make sure it goes back from where it came from to avoid damaging your ROG Ally.
After the ROG Ally removes the back case again, the gamer will automatically go into a power-down state, and you will need to connect the charger to activate it after reinstalling the back case in order to turn it on.
Removing the original back cover
1.Please refer to the steps in the disassembly notes, turn off the console and check the accessories in the package;
PC0110 Circuit Board
PC0110 Circuit Board Holder
PC0110 Back Cover
2.Use the included screwdriver to unscrew the 6 screws on the back cover;
3.Remove the back cover by prying it off using the included disassembly pry bar;
4.Use the supplied screwdriver to remove the trigger and left and right back buttons on the back cover;
Installation of PC0110
1.First, confirm that the PC0110 product can be normally powered on and used;
2.Install the back button and left and right triggers removed from the original back cover on the PC0110 back cover;
3.Install the keypad on the PC0110 back cover;
4.Use screws to secure the PCBA and bracket to the inside of the PC0110 back cover;
5.Install the PC0110 back cover on the game console;
6.Install the rear cover screws;
7.The game console is plugged into the power supply and turned on for use;
1.Long press the power button 2S to switch the light effect on and off;
2.Pressing the power button after powering on the product can switch the light effects, and the product has a total of 5 built-in light effects;
Low battery indicator: indicator light blinks red
Charging indication: indicator light green breathing
Full charge indication: indicator light is always on in green